计算机工程与应用 ›› 2022, Vol. 58 ›› Issue (13): 288-294.DOI: 10.3778/j.issn.1002-8331.2111-0508

• 工程与应用 • 上一篇    下一篇

小车位环境下的自动泊车路径规划与跟踪控制

冯欣阳,李春书,唐风敏       

  1. 河北工业大学 机械工程学院,天津 300401
  • 出版日期:2022-07-01 发布日期:2022-07-01

Parking Path Planning and Path Tracking in Small Parking Spaces

FENG Xinyang, LI Chunshu, TANG Fengmin   

  1. School of Mechanical Engineering, Hebei University of Technology, Tianjin 300401, China
  • Online:2022-07-01 Published:2022-07-01

摘要: 针对小车位泊车路径设计不连续导致位姿调整不平滑的问题,提出一种回旋曲线、圆弧、直线组合的路径规划方法,并基于非时间参考量的跟踪偏差,设计滑模控制器。根据泊车要求和限制条件,规划出泊入路径与调整路径:泊入路径引导车辆以极限位姿进入车位;调整路径通过平滑的路径组合实现车位内的位姿调整。选用指数趋近率设计滑模控制器,利用连续函数代替趋近率中的符号函数,降低抖振影响。仿真结果表明,车辆能够连续、无突变地完成泊车操作,跟踪误差较小,抖振抑制效果较好。

关键词: 自动泊车, 二次路径规划, 滑模控制, 路径组合

Abstract: For the problem of intermittent posture adjustment is caused by design of the discontinuous parking path in the small parking space, a path planning method of combination of cycloid, arc and straight line is proposed, and the tracking deviation of the non-time reference variable is used to design sliding mode controller. First of all, requirement and restrictions during the parking process are considered to devise entry paths and adjustment paths. The vehicle with extreme posture is guided into the parking space by the entry path. Posture adjustment is implemented by a smooth combination of paths of adjustment paths in the parking space. Then, the sliding mode controller is designed with an exponential approach rate;continuous function is used to substitute symbolic function in the approach rate, the effects of jitter is reduced. The simulation results show that parking is finished continuously, small tracking error and outsanding jitter suppression is presented.

Key words: automatic parking, secondary path planning, sliding mode control, curvilinear combination