计算机工程与应用 ›› 2012, Vol. 48 ›› Issue (3): 76-78.

• 网络、通信、安全 • 上一篇    下一篇

无线传感器节点定位中基准锚节点的选择研究

陈晓辉1,陈锦鹏1,雷邦军2   

  1. 1.三峡大学 计算机与信息学院,湖北 宜昌 443002
    2.三峡大学 智能视觉与图像信息研究所,湖北 宜昌 443002
  • 收稿日期:1900-01-01 修回日期:1900-01-01 出版日期:2012-01-21 发布日期:2012-01-21

Research on selection of benchmark anchor node in localization of wireless sensor networks

CHEN Xiaohui1, CHEN Jinpeng1, LEI Bangjun2   

  1. 1.College of Computer and Information Technology, China Three Gorges University, Yichang, Hubei 443002, China
    2.Institute of Intelligent Vision and Image Information, China Three Gorges University, Yichang, Hubei 443002, China
  • Received:1900-01-01 Revised:1900-01-01 Online:2012-01-21 Published:2012-01-21

摘要: 针对无线传感器节点精确定位问题,提出一种通过选择基准锚节点实现提高定位精度的改进最小二乘定位算法。目前最小二乘定位算法未能充分利用通过合理选择基准锚节点达到提高定位精度的作用,鉴于此,提出利用累积相对误差最小方法选择基准锚节点,然后,用最小二乘法定位待测节点。仿真结果表明,在较少的增加算法复杂度的基础上能够较大地提高定位精度。

关键词: 无线传感器网络, 定位精度, 最小二乘法, 相对距离误差

Abstract: To meet the requirement of precise localization of nodes in Wireless Sensor Networks(WSN), this paper proposes an improved least square algorithm based on the selection of benchmark anchor node. The traditional LS localization algorithm does not reasonably take advantage of the selecting of benchmark anchor node to improve the localization precision, in consideration of these, a new method based on the minimum cumulative relative distance error for selecting benchmark anchor node is presented, and then the least square algorithm is adopted to calculate accurate location of the unknown node. The simulation results indicate that the proposed algorithm can greatly improve the localization precision without greatly increasing the algorithm complexity.

Key words: Wireless Sensor Network(WSN), localization precision, least square method, relative distance error