计算机工程与应用 ›› 2010, Vol. 46 ›› Issue (3): 90-93.DOI: 10.3778/j.issn.1002-8331.2010.03.027

• 网络、通信、安全 • 上一篇    下一篇

基于模型散乱点的三维物体重建

林 欣   

  1. 中国科学院 研究生院,北京 100830
  • 收稿日期:2008-07-30 修回日期:2008-10-17 出版日期:2010-01-21 发布日期:2010-01-21
  • 通讯作者: 林 欣

Rebuild 3D object based on module control points

LIN Xin   

  1. Graduate University of the Chinese Academy of Sciences,Beijing 100830,China
  • Received:2008-07-30 Revised:2008-10-17 Online:2010-01-21 Published:2010-01-21
  • Contact: LIN Xin

摘要: 基于三维模型的散乱数据点,通过引入分割平面,对数据集进行划分,将散乱数据划分为n个子集合来重建物体。具体的过程,是通过引入控制参数δη,将满足相应条件的3D散乱点划分到相应的子集合中,然后对各个散乱点子集合进行判断,提取其各个子集上的控制点,构造各个子集的控制点构成的边界。最后,对每两个相邻的边界进行相似性评估,对相似的边界之间通过等比例划分,非相似的边界采用全局优化,从而得到重建的三维物体的模型。经过实验证实该方法高效、方便、准确。

关键词: 模型, 散乱点, 三维重建, 分割平面

Abstract: Based on the three dimensions scattered data points,the data set is divided,and the scattered points is divided into n amount of sets to rebuild object.The detail procedure is that induct the control parameter δ and η to get specific 3D scattered points sub sets under in some conditions,then evaluate each scattered points sub set to extract the control points,and build up the boundary which is formed by the control point.Lastly evaluate the each adjacent boundary using the resemble evaluation,if the adjacent boundaries are resembled,using the method of equal proportion to divide it,else using the method of globle optimation to divide it,therefore,get the 3D model of the object.The experimental results show that this method is effective,convenient and accurately.

Key words: module, scattered points, rebuild 3D object, divide planar

中图分类号: